Draft, Active, Paused: how to actually start a campaign
Saving is not starting
This is the single most common thing new users hit. You build a campaign, you save it, you get a success message, and nothing sends.
That is exactly what is supposed to happen. Every new campaign is created as a Draft, no matter how you made it: from the campaign builder, from the Campaign Builder Agent, from a DFY template, or as a clone of another campaign. The success message means it saved, not that it is running.
And there is no Activate button inside the campaign editor. Do not go looking for one. It lives on the My Campaigns page.
Where to find it
Open My Campaigns in the sidebar. The page is headed Your Campaigns, with Deploy Agents at the top right. The table gives you Campaign, Status, Actions, Today, Total Runs, Created, and the buttons. A new row carries the status Draft and the line "Draft: click Activate to start."
Starting it
- Make sure Chrome is open with the DM Commander extension signed in. Above the table the page tells you the same thing: "Your agents run only while Chrome is open with the extension signed in."
- Find your campaign row and click the green Activate button. It is shown whenever a campaign is Paused or Draft.
- The dashboard shows "Checking your agents…" for up to two minutes while it waits for a real first run.
The four ways that check can end
- "First run finished. Your agents are live." — you are up and running.
- "Ready, but the extension has not started it yet. Check that Chrome is open, the extension is signed in and not paused (click Run Now in the extension)." — the campaign is fine, the browser just has not picked it up yet. Open the extension popup and click Run Now.
- "Extension not connected. Open Chrome with the extension signed in and your agents start." — sign in to the extension and it starts on its own.
- "The first run was skipped: you are signed out of that site in this browser…" — open that site in the same Chrome profile, log in, and it resumes by itself.
What to expect once it is Active
In Copilot the first message is not instant, and that is the design. Within about a minute the Scout saves its first leads. Within about ten minutes the opener is drafted into your Inbox. You approve it, and Step 2 sends it on its next pass plus the normal batch pacing. So the first DM can easily be 15 to 30 minutes out, and nothing sends at all until you approve something.
Pause, Clone and Delete
- Pause — the orange button, shown while a campaign is Active. The status becomes Paused and the green Activate button comes back whenever you want it running again.
- Clone — the copy icon. It asks "Clone this campaign? A copy will be created in Draft status." and makes one named after the original with "(Copy)" on the end. Any steps your plan does not cover yet are copied switched off, and the confirmation tells you so, so you can switch them on the day you add that upgrade.
- Delete — the bin icon, which asks "Delete this campaign and all its actions? This cannot be undone."
The status chips you will see afterwards
Once a campaign is Active, each step reports what it is doing in plain words. Common ones:
- Ready and Ready, waiting for the extension — queued, nothing wrong.
- Next run in X, Next check in X and Next batch in X — normal pacing between runs and batches.
- Done for today, again in X — the daily safety limit for that platform is reached. It starts again after midnight.
- Waiting for you: N drafts and Nothing approved yet — your Inbox needs a visit.
- Waiting for accepts — LinkedIn connection requests are out and waiting.
- Out of sends — this month's DM sends are used up. Reply checking and your Inbox keep running.
- Failed, retrying in X — it will try again on its own.
- Paused after a restriction, Requests paused, again in N days and Other browser — explained in the Troubleshooting articles.
Next: open your Inbox and approve your first opener, so Step 2 has something to send.