Keeping the extension up to date

How you find out there is an update

Your dashboard compares the version your browser is running against the latest one. When yours is behind, a banner appears near the top of the Dashboard page:

Extension update available, with the two version numbers next to it, a bullet list of exactly what changed, and an Update Now button carrying the new version number.

The changelog is worth ten seconds of your time - it is where new platform support and sending improvements show up.

The small x on the banner hides it for that version only. The next release brings it back, so you cannot miss one by dismissing it.

You can also check by hand at any time: the Download Extension button on your dashboard shows the latest version, and the extension Settings page shows the version you are running in its top right corner. If they match, you are current.

The quick way to update (keeps you signed in)

This is the method to use almost every time.

  1. Click Update Now on the banner, or Download Extension at the top of the dashboard.
  2. Unzip the new download over your existing extension folder, replacing the files that are already there.
  3. Go to chrome://extensions.
  4. Click the circular reload icon on the DM Commander card.

That is it. Because the folder is the same one Chrome already knows about, you stay logged into the extension and your campaigns carry on.

The clean way (if something looks wrong)

The banner spells this one out too: "download & unzip, open chrome://extensions, remove the old version first (prevents a duplicate), Load Unpacked, pick the new folder."

  1. Download and unzip the new version into a fresh folder.
  2. Go to chrome://extensions and click Remove on the old DM Commander card.
  3. Make sure Developer mode is still on.
  4. Click Load unpacked and pick the new folder.
  5. Click the extension icon and sign in again with your dashboard email and password.

Removing the old card first matters - loading a second copy leaves you with two extensions trying to run the same campaigns.

"This extension version cannot run this step."

You will see this one in your Agent Activity Log, next to a run that did not go. It means the campaign asked for something your installed version does not know how to do yet - usually a platform step that arrived in a newer release.

The log gives you the fix in three words: "Update the extension."

  1. Update using the quick method above.
  2. Open the popup and press Run Now so you do not wait for the next scheduled check.
  3. Watch the Recent Activity list in the popup - the step should now run normally.

Nothing is lost while a step waits for an update. Leads stay saved, approved messages stay approved, and they go out as soon as the newer version is in.

Good habits

  • Keep one folder. Unzip every update over the same folder and you will never juggle copies.
  • Do not delete the folder. Chrome reads the extension from it every time it starts.
  • Update when the banner shows up, not when something breaks. It takes under a minute.
  • Multiple browsers? Update each one - each has its own copy of the extension.

Next step

Open chrome://extensions, check the version on your DM Commander card against the one on your dashboard's Download Extension button, and reload the card if they differ. Then press Run Now and your agents pick straight up where they left off.

Was this article helpful? Still need help? Submit a ticket